Peugeot 308 LED turn indicator

As I was really really bored with the ordinary bulbs, I wanted to install LED. And as "commonly" known this resulted in hyper flashing. And since there isn't a relay for the 308 (if there is I haven't found it) I needed to install an LED resistor.

This is for the rear indicator. Front 'should' be the same...

This is a fairly simple procedure so I won't be uploading a bunch of hi-res pictures, just one drawing:

- Unplug the connector
- Remove some isolation from + and ground and then 'mix' the wires like in the picture or solder it.
- Tape it together so it doesn't come apart. I also used a cable tie jus to make sure.

Left + is yellow and right + is light blue.

That's it - It's not rocket science!